Avaya Media Processing Server Series System (Software Release 2.1) Manual de usuario descargar pdf (Pagina 257)

Configuration Procedures and Considerations

# P0602477 Ver: 3.1.11 Page 257

4. If displayed values are all correct, select (C)ontinue option. To

modify any current settings:

a. Select the (M)odify option:

b. Press <R

ETURN> to accept current values of items to remain

unchanged.

c. To change an item’s value, type the new value after the prompt. Con-

tinue until all values are done.

(M)odify any of this or (C)ontinue? [M] m

For each of the following questions, you can press <Return> to select the

value shown in braces, or you can enter a new value.

How should the board boot?

1. pROBE+ standalone mode

2. pROBE+ waiting for host debugger via serial connection

3. pROBE+ waiting for host debugger via a network connection

4. Run the Application

Which one do you want? [4]

NETWORK INTERFACE PARAMETERS:

Do you want a LAN interface? [Y]

BOOTP, RARP or FIXEDIP can obtain this Board's IP.

The default method is BOOTP

Enter Y to change the default [N] y

Enter 0 for RARP, 1 for BOOTP, 2 for FIXED [1] 1

New configuration is: BOOTP

Use a subnet mask for the LAN interface? [N]

Should there be a default gateway for packet routing? [N]

HARDWARE PARAMETERS:

Baud rate for serial channels [9600]

Do you want to change the board's clock rate? [N]

Do you want to change the SWT status? [N]

Do you want to change the board's Ethernet address? [N]

ROM BOOTLOADER PARAMETERS:

STARTUP DELAY:

How long (in seconds) to delay before starting up? [5]

1 2 ... 252 253 254 255 256 257 258 259 260 261 262 ... 305 306

Sin comentarios

Avaya Media Processing Server Series System (Software Release 2.1) Manual de usuario Pagina 257