Avaya Media Processing Server Series System (Software Release 2.1) Manual de usuario descargar pdf (Pagina 256)

Avaya Media Processing Server Series System Reference Manual

Page 256 # P0602477 Ver: 3.1.11

TMS Boot ROM

1. Connect a serial console to the CONSOLE port of the TMS. (See

illustration of TMS Front Panel on page 252 and Debug Terminal

Connection on page 250.)

2. Cycle power on the TMS. The ROM banner and current settings will be

displayed on the serial console. Press any key within 5 seconds to

suspend the system from booting.

3. Verify the items are set as follows in ROM:

a. IP address of TMS is obtained from /etc/bootptab.

b. Watchdog timer is ENABLED.

TMS-2000 Rom Version V3.0, Checksum = 0x0434b441

tms_rom.elf, Release Developmental [02/14/00 02:00:10 PM]

--------------------------------------------------------------------------

STARTUP MODE:

Run Application

NETWORK INTERFACE PARAMETERS:

LAN IP address will be obtained from etc/bootptab

LAN interface’s subnet mask is 0xffff0000

HARDWARE PARAMETERS:

Serial channels will use a baud rate of 9600

This board's Ethernet hardware address is 00:80:01:80:01:9C

This board's clock frequency is 80 MHz, bus ratio is 1:1

This board has 32 Megabytes of DRAM

SOFTWARE WATCH DOG TIMER STATUS:

The watch dog timer is ENABLED and will timeout / RESET in 120 seconds.

TFTP BOOT LOADER PARAMETERS

The IP and download file to start will come from the /etc/bootptab file

STARTUP DELAY:

Will wait 5 seconds before start up to allow parameter modifications

--------------------------------------------------------------------------

To change any of this, press Enter, Return, or space key within 5 seconds

(M)odify any of this or (C)ontinue? [C]

1 2 ... 251 252 253 254 255 256 257 258 259 260 261 ... 305 306

Sin comentarios

Avaya Media Processing Server Series System (Software Release 2.1) Manual de usuario Pagina 256