Avaya Quick-Starting Routers and BNX Platforms Manual de usuario descargar pdf (Pagina 45)

Running the Quick-Start Installation Script

6-9

The Technician Interface prompt appears and you have completed the Quick-

Start procedure. Don’t reboot the router or BNX platform after successfully

completing this procedure.

Quick-Start Troubleshooting

If the router or BNX platform cannot ping the Site Manager workstation

during the Quick-Start installation:

— Check the physical connections.

— If the Site Manager workstation is a PC, Distinct or other networking

software must be running for a successful ping. (See Chapter 7 for

Distinct installation instructions.) You can skip the ping test by typing Q

and later verify that the PC is communicating with the router.

— Verify the IP address of the router or BNX platform. Use the

show ip

circuits command in the Technician Interface to make sure that the

physical interface is up and that the IP address is correct. For more

information about the

show command, refer to Using Technician

Interface Scripts.

— Verify the IP address and subnetwork mask address of the Site Manager

PC or workstation.

— Verify that routing is working, if the workstation is on a different network.

Use the show ip routes command in the Technician Interface to examine

the routing table and verify that there is a route or a default route to the

network where the Site Manager workstation is located. For more

information about the

show command, refer to Using Technician

Interface Scripts.

Note: Boot with the ti.cfg ﬁle and run install.bat once to conﬁgure the initial

interface only. To conﬁgure other interfaces, use Site Manager, Quick2Conﬁg,

or other router management software to create new conﬁgurations, as

described in Chapter 11.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 119 120

Sin comentarios

Avaya Quick-Starting Routers and BNX Platforms Manual de usuario Pagina 45