Avaya Quick-Starting Routers and BNX Platforms Manual de usuario descargar pdf (Pagina 105)

A-1

Appendix A

Sample Install.bat Script

To perform the Quick-Start installation procedure on your router or BNX

platform, run the install.bat script as described in Chapter 6. A typical script

follows. Your script will vary, depending on your router or BNX platform model

and network conﬁguration.

------------------------------------------------------------------------

#### # # # # # #### ##### # # ## ### # # ###

# # # # # # ## # # # # # # # # # # # #

#### # # # # # # ### # # # # # # ### ## ###

# # ##### # # ## # # # # # # # # # # # # #

#### # # # # # #### # # # ## # # # # ###

### # # ### ## # # ### ##### # ### #####

# # # # # # # # # # # # # # #

# # # # # # ## ### ### # # # ### #

# # # # # # # # # # # ##### # # #

### #### ### ## # # ### # # # # # #

Version 1.108

------------------------------------------------------------------------

Introduction

------------

This part of the Quick-Start procedure configures the initial IP

network interface on the router. You perform this procedure so that

the router can communicate with the Site Manager workstation.

Each step of this procedure is further described in the

Quick-Start manual. As you perform the procedure, refer to the Quick-

Start manual for additional helpful information and examples.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 119 120

Sin comentarios

Avaya Quick-Starting Routers and BNX Platforms Manual de usuario Pagina 105