Avaya Quick-Starting Routers and BNX Platforms Manual de usuario descargar pdf (Pagina 44)

Quick-Starting Routers and BNX Platforms

6-8

Figure 6-4. Summary Information for a Quick-Start Installation

Save the conﬁguration ﬁle as startup.cfg.

Accept the default name of startup.cfg. You save this initial IP conﬁguration

to the ﬁle to maintain a permanent copy. If you do not save the conﬁguration

to a ﬁle, you will lose it the next time you reboot the router or BNX platform.

The router or BNX platform then tests the IP interface conﬁguration by

“pinging” its own interface. If successful, it prompts you for the IP address of

the Site Manager workstation.

6. Enter the IP address of the Site Manager workstation.

The router or BNX platform pings the Site Manager workstation. If the ping is

successful, the initial IP interface is enabled and the script displays this

message:

Quick-Start Installation Completed

Note: If you terminate the installation script, reboot the router or BNX

platform using the ti.cfg ﬁle before you rerun the Quick-Start installation

script.

Configuration Summary

---------------------

Link Module: QE/NF

Connector: 1

Slot: 2

Circuit Name: E21

IP address: 192.168.125.34

IP subnetwork mask: 255.255.255.0

Routing Protocol: RIP

Default Rt. Listen: YES

TFTP Default Volume: 2:

FTP Default Volume: 2:

TI TELNET: No

Press [RETURN] to continue:

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 119 120

Sin comentarios

Avaya Quick-Starting Routers and BNX Platforms Manual de usuario Pagina 44