Avaya Quick-Starting Routers and BNX Platforms Manual de usuario descargar pdf (Pagina 27)

Filling Out the Network Information Worksheet

2-5

Site Manager Workstation Information

IP address of the workstation on which the Site Manager

software will be installed. This information is requested

when the installation is tested at the end of the

procedure.

192.32.10.12

WAN Information

The following information about enabling Frame Relay, PPP, and SMDS from the installation script is for

experienced users only. Normally these protocols are implemented from Site Manager on an additional

interface.

Frame Relay Information

(To enable Frame Relay on a synchronous connector on this initial IP interface)

Enable Frame Relay on the interface? Yes

Management protocol that communicates with the

Frame Relay network.

LMI

DLCI addressing types. ADDR Q.922

Frame Relay address ﬁeld length. 2 bytes

Frame Relay PVC ID. 30

PPP Information

(To enable PPP on a synchronous connector on this initial IP interface)

Enable PPP on the interface? Yes

IP address of peer connection. 192.32.4.2

Enable PPP Echo protocol? Yes

Number of seconds between transmission of echo

requests.

Acceptable loss of Echo-Reply packets. 3

Enable local authentication protocol? Yes

Local PAP ID for this interface. 192.32.4.1

Local PAP password (optional). lpwd

Authentication protocol enabled on remote peer? Yes

Remote peer PAP password. rpwd

Enable Link Quality Reporting (LQR) protocol? Yes

(continued)

Table 2-1. Network Information Worksheet

(continued)

Requested Information Example Your Information

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 119 120

Sin comentarios

Avaya Quick-Starting Routers and BNX Platforms Manual de usuario Pagina 27