Avaya Connecting ASN Routers and BNX Platforms to a Network Manual de usuario descargar pdf (Pagina 98)

Connecting ASN Routers and BNX Platforms to a Network

B-2

Hints

This section contains a few hints for setting up ASN routers.

• We recommend that you ﬁrst install a router in the same site as your BOOTP

server, Site Manager workstation, and intermediate routers to test the software

image, conﬁguration ﬁle, and routing path. This test provides you with the

startup and troubleshooting experience you need to perform these tasks on

routers at remote sites. After you perform the test, move the test router to the

remote location you want, modify the conﬁguration ﬁle for that router, and set

up the new paths.

• After you build and test a router conﬁguration ﬁle, make copies of it on the

Site Manager workstation. Then modify the copies for each router in your

network rather than starting from scratch. To avoid mix-ups, make sure the

ﬁlename you assign to each conﬁguration ﬁle is unique and meaningful for

each router.

• If you use TFTP to transfer the software image ﬁle to upgrade or restore the

router’s ﬁle system, specify the image shipped for the router you purchased. If

you boot a router with an image designed for use with another router type, the

router will fail to boot.

• If you upgrade all routers in the paths between the routers and the BOOTP

server to Version 7.80 or later (BNX Version 5.00 or later) before you set up

the paths, it may be easier to isolate BOOTP and TFTP conﬁguration errors

on the network.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 104 105 106

Sin comentarios

Avaya Connecting ASN Routers and BNX Platforms to a Network Manual de usuario Pagina 98