
Troubleshooting Network Boot Problems
A-9
Displaying the ASN’s Parameter Settings
Display the router parameter settings to determine
• Whether the ASN is set to boot using a local boot image or a remote boot
image
• Whether the ASN is set to configure using a local configuration image or a
remote configuration image
• The configuration of the synchronous and Ethernet connectors
Enter the following Technician Interface command to display the ASN parameter
settings:
getcfg
The following sample responses show the default settings:
Boot Options
boot image=network
boot config=network
Netboot Parameters:
Slot 1:
COM11...EZ-Install
COM12...EZ-Install
XCVR21..None
XCVR22..None
XCVR31..None
XCVR32..None
Slot 2:
XCVR21..None
XCVR22..None
COM31...EZ-Install
COM32...EZ-Install
The XCVR21/22/31/32 parameters show the current setting of the ASN’s
Ethernet connectors.
The
COM11/COM12 and COM31/COM32 parameters show the current settings of
the ASN’s synchronous connectors.
Comentarios a estos manuales