Avaya Connecting ASN Routers and BNX Platforms to a Network Manual de usuario descargar pdf (Pagina 49)

Setting Up a UNIX Boot Server

2-11

You may want to specify a static route in a multihop environment or in an

environment using routing protocols such as RIP, where minor routing update

delays may extend the time it takes to Netboot.

Editing the inetd.conf File

Add the following line to the inetd.conf ﬁle to set up a static route:

route add

is the IP address of the ASN or its network.

is the IP address of the network destination to which packets are to be

addressed.

<hops>

is the number of hops to the network destination.

Verifying the Routes

After adding a static route for each path to the booting routers, enter the following

command to display the routing table and verify the route you added:

netstat -r

Loading the Changes into Memory

Once you modify the inetd.conf ﬁle, you must force the operating system to reread

it by rebooting the workstation or by issuing a hang-up signal.

In most cases, reboot the workstation. Issue a hang-up signal if the workstation is

performing a task that you do not want to interrupt.

Rebooting

Reboot your workstation as follows:

1. Log in as

root.

2. Execute the following command:

/etc/shutdown now -r

The

-r

ﬂag reboots the workstation.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 105 106

Sin comentarios

Avaya Connecting ASN Routers and BNX Platforms to a Network Manual de usuario Pagina 49