Avaya Connecting ASN Routers and BNX Platforms to a Network Manual de usuario descargar pdf (Pagina 74)

Connecting ASN Routers and BNX Platforms to a Network

4-2

Conﬁguring the Router Boot Source

To use Netboot, you use the bconﬁg command to specify the IP address of the

server where the ASN conﬁguration ﬁle or software image resides. To use

Directed Netboot, you use the

bconﬁg command to specify the IP address of the

server and the full pathname of the software image and conﬁguration ﬁle.

bconﬁg Command Format

To conﬁgure an interface for Netboot, use the following format of the bconﬁg

command:

bconﬁg -d [image|conﬁg] [local|network]

To conﬁgure an interface for Directed Netboot, use the following format:

bconﬁg [image|conﬁg] [local|network [

]]

You must use the

bconﬁg command twice: once to specify the location of the

software image, and again to specify the location of the conﬁguration ﬁle.

Refer to Table 4-1 for a complete description of the

bconﬁg command.

Note: The ifconﬁg and bconﬁg

commands will commit the MIB when you

execute them; therefore, you should not use them if you do not want a MIB

commit. (The

getcfg command does not commit the MIB.)

Caution: For an ASN to perform a successful Netboot, you must use the same

bconﬁg setting for each slot in the stack; otherwise, the ASN will behave

unpredictably. If the settings are not the same, reset them before booting the

router. If the settings differ, the

getcfg command detects this and displays each

different setting. If the settings are the same, you will see only one setting on

your screen display.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 105 106

Sin comentarios

Avaya Connecting ASN Routers and BNX Platforms to a Network Manual de usuario Pagina 74