Avaya Connecting ASN Routers and BNX Platforms to a Network Manual de usuario descargar pdf (Pagina 90)

Connecting ASN Routers and BNX Platforms to a Network

A-10

The possible boot image and boot config settings are network and local.

If the setting is

network, the ASN requests the boot image or conﬁguration ﬁle

from a BOOTP server when booting. If the setting is

local, the ASN uses the

boot image or conﬁguration ﬁle stored in its ﬁle system.

The possible settings for synchronous connectors are as follows:

• EZ-Install (the default setting)

• The IP address, next-hop IP address, subnet mask, and WAN protocol (Bay

Networks HDLC or Frame Relay)

The possible settings for Ethernet connectors are as follows:

•

None (the default setting)

• The IP address with subnet mask

Changing the ASN’s Parameter Settings

Refer to this section to conﬁgure the ASN to local boot or Netboot its image or

conﬁguration.

Enter the following command using the Technician Interface:

bconﬁg [image | conﬁg] [network | local]

Use

image if you are changing the source of the software image, or conﬁg if you

are changing the source of the conﬁguration ﬁle.

Use

network if you are conﬁguring the ASN to use the boot image or

conﬁguration ﬁle on the BOOTP server when booting, or

local if you are

conﬁguring the ASN to use the boot image or conﬁguration ﬁle stored on its own

ﬁle system.

For example, to conﬁgure the ASN to use a local boot image when booting, enter

the following command:

bconﬁg image local

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 105 106

Sin comentarios

Avaya Connecting ASN Routers and BNX Platforms to a Network Manual de usuario Pagina 90