Avaya Connecting ASN Routers and BNX Platforms to a Network Manual de usuario descargar pdf (Pagina 63)

Configuring Network Booting

3-13

Parameter: Connector Protocol Mask

Default: Point to Point

Options: Point to Point

| Point to Point Internal Clock | Fr Relay Annexd | Fr Relay

Annexa

| Fr Relay LMI

Function: During the boot process the router will conﬁgure the synchronous

interface to the speciﬁed protocol.

Instructions: Specify the desired protocol option.

MIB Object ID: 1.3.6.1.4.1.18.3.3.2.10.3.1.7

Parameter: Connector State

Default: Enable

Options: Enable

| Disable

Function: Enables or disables the connector parameters. If you set this parameter to

Disable, the router cannot Netboot.

Instructions: If you do not want to use the settings on the Netboot Interfaces window,

select Disable. You must set this parameter to Enable to use any of the

other four parameters in the window.

MIB Object ID: 1.3.6.1.4.1.18.3.3.2.10.3.1.1

Setting Up Routing Paths

You set up the routing path between a BOOTP server and a booting routers by

• Enabling BOOTP relay interfaces on all routers between the server and the

booting router

• Creating a BOOTP Relay Agent Forwarding Table for each router in the path

• Creating a BOOTP Client Interface Table for the upstream router when the

booting router is on a Frame Relay PVC in group access mode

Note: If you are booting over an Ethernet LAN and the Site Manager

workstation is directly cabled to the LAN, you do not need to conﬁgure a

BOOTP routing path.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 105 106

Sin comentarios

Avaya Connecting ASN Routers and BNX Platforms to a Network Manual de usuario Pagina 63