Avaya Connecting ASN Routers and BNX Platforms to a Network Manual de usuario descargar pdf (Pagina 37)

Selecting a Boot Configuration

1-17

If the conﬁguration ﬁle meets your network requirements, the ASN starts bridging

and routing trafﬁc.

You can use the Site Manager Statistics Manager and Events Manager tools to

verify that the router is routing trafﬁc according to the conﬁguration you want.

(See the manual Managing Routers and BNX Platforms.)

Netboot

The Netboot option requires the following steps:

1. You use the Conﬁguration Manager in local mode to create a complete

conﬁguration ﬁle for the router. (See Chapter 3 and the manual Conﬁguring

Routers or Conﬁguring Customer Access and Trunks (BNX Software),

depending on the type of installed software.)

2. You set up the network to support BOOTP. (See Chapter 2.)

3. You use Site Manager to enable BOOTP on each router interface in the path

between the router and the BOOTP server. (See Chapter 2.)

4. The person at the ASN site establishes a Technician Interface session (or you

establish a session via modem). (See the manual Installing and Maintaining

ASN Routers and BNX Platforms.)

5. The person at the ASN console uses the

bconﬁg and ifconﬁg commands to

conﬁgure a synchronous or Ethernet interface. (See Chapter 4 and the manual

Installing and Maintaining ASN Routers and BNX Platforms.)

6. You install the netboot.exe ﬁle in the BOOTP server’s ﬁle system, and make

sure the image and application ﬁles reside in the same directory.

(See Chapter 2.)

7. The person at the router site boots the router. (See the manual Installing and

Maintaining ASN Routers and BNX Platforms.)

After the router boots, it gets a configuration file from a BOOTP server and

loads the software image from the local ﬁle system.

Note: On a Frame Relay circuit, make sure the upstream router software is

Version 7.71 or later (or BNX Software Version 6.00 or later).

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 105 106

Sin comentarios

Avaya Connecting ASN Routers and BNX Platforms to a Network Manual de usuario Pagina 37