Avaya Troubleshooting Routers Guía para resolver problemas descargar pdf (Pagina 114)

Troubleshooting Routers

6-4

308656-14.00 Rev 00

Static Configuration Conflict Event Message

The node number associated with the interface is already being used by another

node on the same segment.

Set the node number of the interface to zero (0) so that it will configure

dynamically, or define a unique node ID.

Troubleshooting DLSw

This section assumes that you have isolated a problem to data link switching

(DLSw). If not, refer to Chapter 2 to determine whether these instructions apply to

your problem.

You can turn on extended DLSw log messages by setting the Max Sessions

attribute of the wfDls object to 1111. Nortel Networks recommends that you turn

off extended DLSw messages when you finish examining the log to test or

troubleshoot a DLSw connection.

Troubleshoot a DLSw connection as follows:

Use the Events Manager or the Technician Interface to filter the log to

display messages of all severity levels for DLSw.

The Technician Interface command is as follows:

log -fftwid -eDLS -s

<slot_no.>

Example

If you are filtering events from slots 3 and 4, enter the following command:

log -fftwid -eDLS -s3 -s4

Make sure that the DLSw MTU size matches the synchronous line MTU

size.

Unnecessary packet fragmentation can occur when these settings do not

match.

Use the Technician Interface or the Statistics Manager to inspect the

global source route bridge (SRB) settings, such as the internal LAN ID,

the group LAN ID, and the bridge ID.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 267 268

Sin comentarios

Avaya Troubleshooting Routers Guía para resolver problemas Pagina 114