
Configuring WAN Line Services
8-22
117345-B Rev. 00
Figure 8-8. Timeslots Window
Testing FT1 Lines
The following sections describe how to use the Configuration Manager to test FT1
link module interfaces:
• About the Tests
• Setting Port Test Parameters
• Running Port Tests
About the Tests
While in dynamic mode, you can use the Configuration Manager to trigger port
actions to test the quality of FT1 connections. The tests you can run perform the
following actions:
• Transmit specific codes to the remote end of the FT1 connection
• Introduce deliberate error patterns into the port BERT bit stream
Comentarios a estos manuales