Avaya Configuring WAN Line Services Manual de usuario descargar pdf (Pagina 178)

Configuring WAN Line Services

8-18

117345-B Rev. 00

Setting the Local HDLC Address

Specify the 1-byte HDLC address of this logical line as follows:

•DCE

• DTE

• An explicit address value: 2, 4, 5, 6, or 7

Use unique HDLC addresses for the local and remote interfaces at either end of

the point-to-point circuit. For example, if the remote address is DTE, configure

the local address as DCE.

If you configure X.25 on this line, set this parameter to either DCE or DTE.

See the Local HDLC Address parameter on page A-52

for information.

Setting the Remote HDLC Address

Specify the 1-byte HDLC address of the remote FT1 interface as follows:

•DCE

• DTE

• An explicit address value: 2, 4, 5, 6, or 7

Use unique HDLC addresses for the local and remote interfaces at either end of

the point-to-point circuit. For example, if the local address is DTE, configure the

remote address as DCE.

If you configure X.25 on this line, set this parameter to either DCE or DTE.

See the Remote HDLC Address parameter on page A-52

for information.

Setting the CRC Size

By default, the router uses the 16-bit CRC type. The router appends a 16-bit CRC

to the transmitted frames and performs a 16-bit CRC on received frames. You can

change to 32-bit CRC, where the router appends a 32-bit CRC to transmitted

frames and performs a 32-bit CRC on received frames.

You can set CRC size for the logical line.

See the CRC Size parameter on page A-52

for information.

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 293 294

Sin comentarios

Avaya Configuring WAN Line Services Manual de usuario Pagina 178