Avaya Configuring WAN Line Services Manual de usuario descargar pdf (Pagina 153)

Configuring MCE1 and MCT1 Services

117345-B Rev. 00

7-41

Setting the Signal Level (MCT1 Only)

By default, the T1 transmit power level is 0.0 dB. Specify a decibel level from

-15 dB to 1.5 dB, according to the length of the cable or as determined by the

carrier. See “Setting the Signal Level” earlier in this chapter for more information.

Enabling or Disabling the International Bit (MCE1 Only)

By default, MCE1 does not use the international bit in E1 frames. Enable or

disable use of the international bit for testing an MCE1 interface.

Running Port Tests

Port tests affect all logical lines associated with a port. To run MCE1 or MCT1

port tests:

Table 7-4

describes the BERT test commands you can send on any MCT1 or

MCE1 port. Table 7-5 describes the loopback commands you can send on an

MCT1 port only.

Site Manager Procedure

You do this System responds

1. Set the test parameters in the Port Actions

window. See “Setting Port Test

Parameters” earlier in this chapter.

2. Click on

Apply

3. To start a test, click on the appropriate

Send

command.

4. Repeat step 3

for each test you want to

run.

5. Click on

Done

. The MCE1 or MCT1 Port Parameters

window opens.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 293 294

Sin comentarios

Avaya Configuring WAN Line Services Manual de usuario Pagina 153