Avaya Configuring MPOA Services Manual de usuario descargar pdf (Pagina 36)

Configuring MPOA and NHRP Services

2-6

309249-14.00 Rev 00

Based on each type of link between two MPSs, proceed as follows:

Starting NHRP on an ATM LEC Service

To allow LANE and normally routed traffic to flow through an ATM LEC service

and between MPSs, enable IP and optionally a routing protocol (RIP or OSPF) on

that IP interface.

To allow NHRP address resolution requests and replies to flow through the same

ATM LEC service and between MPSs, you must enable NHRP on that service.

You can use either the BCC or Site Manager to add IP, RIP or OSPF, and NHRP

to an LEC service.

Using the BCC

To add IP, RIP or OSPF, and NHRP to an existing LEC service:

Navigate to the appropriate lec-service prompt and enter:

nhrp

Navigate back to the lec-service prompt, and enter:

ip address

<IP_address>

mask

<subnet_mask>

At the resulting IP interface prompt, add the desired routing protocol

(RIP or OSPF):

rip

Note:

Enabling RIP or OSPF on an LEC, PVC, or Classical IP (SVC) service

is unnecessary if your network already has a routed path between MPSs.

MPS Link Service Go to

Emulated LAN (ELAN) LEC service Starting NHRP on an ATM LEC Service

Permanent virtual circuit

(PVC)

PVC service Starting NHRP on an ATM PVC

Service

Switched virtual circuit

(SVC)

Classical IP service Starting NHRP on an ATM Classical IP

(RFC 1577 SVC) Service

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 147 148

Sin comentarios

Avaya Configuring MPOA Services Manual de usuario Pagina 36