Avaya Configuring MPOA Services Manual de usuario descargar pdf (Pagina 32)

Configuring MPOA and NHRP Services

2-2

309249-14.00 Rev 00

Starting the MPOA Server

To start the MPOA server, you must perform the following steps:

Start ATM on the router. (See Configuring ATM Services.)

Configure any ATM PVCs, SVCs (Classical IP), and LAN emulation client

(LEC) services that you need for MPOA/NHRP to operate within your

specific network topology. (See Chapter 1 and Configuring ATM Services.)

Be sure to:

• Specify LANE data encapsulation for each LEC that you require.

• Specify LLC-SNAP data encapsulation for each PVC that you require.

• Configure IP and NHRP on each LEC, PVC, and Classical IP (SVC)

service.

Create an MPOA service record.

Add an MPS to the MPOA service record.

Ensure that a LECS has been configured on your network.

Map any LEC services on the router to the desired local MPS.

Creating an MPOA Service Record

To run an MPOA server over ATM, you must first create an MPOA service record

on an ATM interface. Then you add one or more MPOA servers (MPSs) to the

MPOA service record.You can use the BCC or Site Manager to accomplish this

using default values for all parameters.

Using the BCC

To create an MPOA service record, navigate to the appropriate ATM interface

prompt and enter:

mpoa-service

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 147 148

Sin comentarios

Avaya Configuring MPOA Services Manual de usuario Pagina 32