Avaya Configuring MPOA Services Manual de usuario Pagina 140

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 148
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 139
Configuring MPOA and NHRP Services
D-4
309249-14.00 Rev 00
BCC Configuration Sequence
The following command sequence implements the example configuration
described in Figure D-1
and Table D-1. The example assumes that you have
already logged on to Router A.
1.
Start the BCC interface.
[2:1]LAB2$ bcc
Welcome to the Bay Command Console!
* To enter configuration mode, type config
* To list all system commands, type ?
* To exit the BCC, type exit
2.
Enter BCC configuration mode.
bcc> config
Reading configuration information, please wait . . . done.
box#
3.
Identify ATM interface slots.
box# lso
atm/5/1 board/5 ftp snmp
board/1 console/1 ip telnet
board/2 ethernet/2/1 tftp
4.
Go to the ATM interface configured on slot 5, connector 1.
box# atm 5/1
atm/5/1#
Vista de pagina 139

Comentarios a estos manuales

Sin comentarios