Avaya Configuring MPOA Services Manual de usuario descargar pdf (Pagina 132)

Configuring MPOA and NHRP Services

C-12

309249-14.00 Rev 00

show nhrp

The

show nhrp

command displays information about the Next Hop Routing

Protocol (NHRP). You can enter the following optional versions of the

show nhrp

command:

show nhrp client configuration

The

show nhrp client configuration

command displays configuration

information about the NHRP client on the router. When you enter this

command,

the BCC displays the following information:

show nhrp client configuration show nhrp server configuration

show nhrp client stats show nhrp server stats

show nhrp interfaces

Client Enable The configured state of this NHRP client (enabled or disabled)

Hold Time The period in seconds during which client information is valid

Link Protocol The type of layer 2 network (ATM or frame relay)

Network Protocol Type of layer 3 protocol (for example, IP)

Pending Requests The maximum number of pending requests allowed for this NHRP

client

Registration Interval The interval in seconds between NHRP client registration

requests, each of which refresh and update the client’s next-hop

cache. The interval must be less than the NHRP client hold time.

Request Retries The number of times that the NHRP client generates NHRP

registration requests. If an NHRP registration response is not

received after the specified number of attempts, the NHRP client

returns an error to the local requesting entity (the MPS).

Request Timeout The maximum amount of time that the NHRP client waits to

receive a reply from an NHRP server

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 147 148

Sin comentarios

Avaya Configuring MPOA Services Manual de usuario Pagina 132