Avaya Business Communication Manager 5.0 - Configuration - Devices Manual de usuario descargar pdf (Pagina 81)

Nortel Business Communication Manager 5.0

Configuration — Devices

NN40170-500 02.04 Standard

August 2009

Hunt Group configuration

The information in this section applies to both the BCM50 and the BCM450

platforms running BCM 5.0.

The Hunt Groups panel allows you to set up call groups that are assigned a

common hunt group DN for incoming calls. The calls then are distributed to

the member telephones.

The following paths indicate where to configure hunt groups in Element

Manager and through Telset Administration:

• Element Manager: Configuration > Telephony > Hunt Groups

• Telset interface: **CONFIG > System prgrming > Hunt Groups.

Configuring Hunt Groups navigation

• Configuring Hunt Group general settings (page 81)

• Adding members to Hunt Groups (page 85)

• Deleting members from Hunt Groups (page 85)

• Changing order of members in Hunt Groups (page 86)

• Assigning lines to Hunt Groups (page 86)

• Deleting lines from Hunt Groups (page 87)

Configuring Hunt Group general settings

When you first set up a Hunt Group, you must identify how calls are handled

among the group.

Procedure steps

Step Action

1 Click Configuration > Telephony > Hunt Groups.

2 On the Hunt Groups table, select the hunt group you want to configure.

3 Fill out the columns across the table as required.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 257 258

Sin comentarios

Avaya Business Communication Manager 5.0 - Configuration - Devices Manual de usuario Pagina 81