Avaya Business Communication Manager 5.0 - Configuration - Devices Manual de usuario descargar pdf (Pagina 47)

Basic parameters for analog sets and devices configuration 47

Nortel Business Communication Manager 5.0

Configuration — Devices

NN40170-500 02.04 Standard

August 2009

Assigning a line to an analog telephone

Use the following steps to assign a line to an analog telephone.

Procedure steps

Step Action

1 Click Configuration > Telephony > Sets > Active Sets > Line Access.

2 Select the DN to which you want to add a line.

3 In the details for the DN section, select the field that you want to modify.

--End--

Variable Definitions

Hotline

The following settings are not valid (N/V) or are limited on analog devices.

Keep DN Alive N/V

Silent monitor supervision Do not select

DND on Busy Do not select

Priority call Do not select

Auto hold Do not select

Allow Link Select check box (telephones only)

All other settings are variable, based on your system requirements.

Variable Value

Name Enter a name that identifies the user or the location (maximum of

seven digits).

Port Enter the port number for the device.

Pub. OLI Enter or confirm the number that displays at the far end for calls

going out over the public network (only on digital and VoIP

trunks).OLI numbers can be bulk changed using the Renumber

button available under Configuration>Telephony>Sets>All

DNs.

Priv. OLI Enter or confirm the number that displays at the far end for calls

going over the private network. This number is usually the same

as the DN (only on digital and VoIP trunks). OLI numbers can be

bulk changed using the Renumber button available under

Configuration>Telephony>Sets>All DNs.

Variable Value

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 257 258

Sin comentarios

Avaya Business Communication Manager 5.0 - Configuration - Devices Manual de usuario Pagina 47