Avaya Configuring Routers Manual de usuario descargar pdf (Pagina 25)

Using the Configuration Manager

1-7

Dynamic Mode

You use dynamic mode if you can access the router over the network and want to

conﬁgure the system in real time.

To run the Conﬁguration Manager in dynamic mode, you must

• Conﬁgure SNMP options that identify the router you want to conﬁgure and

that provide Site Manager with an SNMP community that has read-write

access to the router.

• Use the Conﬁguration Manager to perform all desired router conﬁguration

functions (adding interfaces, and so forth), as described in subsequent

chapters.

• Save the conﬁguration ﬁle to the router’s ﬁle system if you want to maintain a

record of the changes you made. Refer to Chapter 3.

See the section “Starting a Conﬁguration in Dynamic Mode” later in this chapter

for information on how to begin conﬁguring the router in dynamic mode.

Note:

You should not use dynamic mode to create an entirely new router

conﬁguration ﬁle. Instead, use dynamic mode to make minor changes to an

existing conﬁguration. It is safer to create a conﬁguration and make major

changes using local or remote mode, since it is easier in these modes to

correct mistakes or redo a conﬁguration.

Also, conﬁguring a router in dynamic mode can interrupt service, depending

on the attributes you modify. Be careful when modifying the global attributes

of protocols. For example, changing the size of the bridge forwarding table

will ﬂush and recreate the table, which can brieﬂy affect performance.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 103 104

Sin comentarios

Avaya Configuring Routers Manual de usuario Pagina 25