
Configuring Ethernet, FDDI, and Token Ring Services
B-8
308623-14.00 Rev 00
show ethernet flow-control
The
show ethernet flow-control
command shows the status of the slots on which
flow control is enabled.
This command allows for the following command filters (flags) and filter
arguments:
The output includes the following information:
-circuit
<circuit_name>
Displays information about the specified circuit only.
-slot
<slot_number>
Displays information about the specified slot only.
<circuit_name>
Displays information about the specified circuit only.
Slot/Conn Slot and connector number.
Circuit Circuit number.
Flow Ctrl Enable Whether flow control is enabled on the slot.
Pause Zero Enable Whether transmit pause 0 is enabled on the slot.
Pause Time Pause time specified for the transmitter.
Received FlowCtrl Frames Number of flow control frames received by the
interface.
Transmit FlowCtrl Frames Number of flow control frames sent by the interface.
Received Unsupported Opcodes Number of frames received by the interface that do
not have a Pause opcode.
Comentarios a estos manuales