Avaya Configuring Ethernet, FDDI, and Token Ring Services Manual de usuario descargar pdf (Pagina 122)

Configuring Ethernet, FDDI, and Token Ring Services

B-4

308623-14.00 Rev 00

show ethernet auto-neg

The

show ethernet auto-neg

command displays the line speed characteristics of Ethernet

circuits that are configured with automatic line negotiation. Some Ethernet modules can

run at either 10 Mb/s or 100 Mb/s using a hardware process to detect the speed to use. Use

this command to identify the status of autonegotiation.

This command allows for the following command filters (flags) and filter arguments:

The output includes the following information:

Errors Total number of errors (see

show ethernet errors

MTU Maximum transmission unit (MTU) size for frames on this line.

Speed Circuit’s configured line speed: 10 Mb/s or 100 Mb/s.

-circuit

<circuit_name>

Displays information about the specified circuit only.

-slot

<slot>

Displays information about the specified slot only.

<circuit_name>

Displays information about the specified circuit only.

Slot/Conn Slot location of the Ethernet module within the chassis and the

connector number.

Circuit Name of the circuit associated with this line.

State State of the line driver: Disabled, Down, Init (initializing), Not Present

(enabled but not yet started), or Up.

Auto-Negotiation State Disabled, Configuring, Complete, Parallel Detect Failure.

Remote Signaling Detected or Not Detected.

Line Capability Being Used 10 or 100 Mb/s.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 155 156

Sin comentarios

Avaya Configuring Ethernet, FDDI, and Token Ring Services Manual de usuario Pagina 122