
Configuring ATM and MPLS Services
B-4
117374-C Rev 00
errors
[
-enabled
|
-disabled
] [
-slot
<slot>
|
-slot
<slot>/<connector>
]
[
-sample
]
Displays the ATM module physical interface errors table for the ATM routing engine
(ARE).
The output includes the following line receive error statistics:
phy config
[
-enabled
|
-disabled
] [
-slot
<slot>
|
-slot
<slot>/<connector>
]
[
-sample
]
Displays the ATM module physical interface table for the ATM routing engine (ARE).
The output includes the following physical interface statistics:
Slot Slot number on which the ATM physical interface resides.
Conn Connector number of the physical interface.
Circuit Circuit name assigned to the interface.
Invalid Headers Number of received cells dropped because of incorrect header
format.
Over Sized SPDUs Number of packets dropped because their size was greater than the
MTU specified for the interface.
Crc Errors Cyclical redundancy check errors.
Crc10 Errors Number of OAM cells dropped because they had an invalid CRC-10.
Rx Lack of Rsrcs Number of packets dropped because no host buffers were available
to hold the incoming data.
Slot Slot number on which the ATM physical interface resides.
Conn Connector number of the physical interface.
Circuit Circuit name assigned to the interface.
Phy State Physical state of the ATM line (Up or Down).
Speed (Mbps) Estimate of the interface's current bandwidth: 155,520,000 Mb/s,
140,000,000 Mb/s, 100,000,000 Mb/s, 44,736,000 Mb/s, or
34,368,000 Mb/s.
Type Interface type: OC-3 MM (multimode), OC-3 SM (single mode),
DS-3, or E-3.
Framing Mode Transceiver mode: SDH, SONET, CBIT, M23, G751, or G832.
Comentarios a estos manuales