
Site Manager Parameters
117374-C Rev 00
A-13
Parameter: Use Hardware MAC Address
Path: Configuration Manager > Circuits > Edit Circuits > Edit > Interface Attributes
Default: Enable
Options: Enable
|
Disable
Function: Specifies whether or not to use the hardware MAC address for this interface.
When enabled, the Configuration Manager uses the ATM hardware MAC
address of the link module as the end-station identifier when automatically
generating the user part (suffix) of an SVC service record ATM address.
When disabled, the Configuration Manager uses the value specified in the MAC
Address Override parameter to assign the end-station identifier when
automatically generating the user part (suffix) of an SVC service record ATM
address.
Instructions: Accept the default, Enable, if you want to use the MAC address of the ATM
interface when automatically generating the end-station identifier portion of the
ATM address user part.
Set this parameter to Disable if you want to use the MAC Address Override
value when automatically generating the end-station identifier portion of the
ATM address user part.
If you set this parameter to Disable, you must enter a value for the MAC
Address Override parameter.
MIB Object ID: 1.3.6.1.4.1.18.3.4.23.1.1.1.18
Comentarios a estos manuales