Avaya Using Technician Interface Software Manual de usuario descargar pdf (Pagina 75)

Using Operating Commands

3-13

An IPX address in decimal notation consists of a 4-byte network address and a

6-byte host address, where each byte is a number between 0 and 255, inclusive,

and each byte is separated from the next byte by a period (for example,

0.1.23.47.0.0.0.1.2.55).

[

-t

] [-r

<repeat_count>

] are optional. These parameters are as follows:

<timeout> is the number of seconds for each ping to time out. If the system

receives a response to a ping after it has timed out, the system does not send an

“alive” message to the console. The default is 5.

<repeat_count> is the number of ping messages to send. The system does not

wait for the timeout before sending the next ping. Enter a value between 0 and 10

(inclusive). The default is 1.

The console displays one of the following messages when you issue a

ping -ipx

command. (If you enter a value other than 0 in the <repeat count> argument, the

system displays one of the following messages for the default ping, plus one for

each additional ping):

• An

alive message: This message appears if the system receives an IPX reply

packet from the target device within the <timeout> allowed. A sample

message follows:

IPX ping: 0xAB12.0xCD1234 is alive

•A does not respond message: This message appears if the IPX address of the

target device is resolved, but the system does not receive an IPX reply packet

from the target device within the <timeout> allowed. A sample message

follows:

IPX ping: 0xAB12.0xCD1234 does not respond

•A target address is unreachable message: This message appears if the

local Bay Networks router cannot ﬁnd the speciﬁed network address in its

table of IPX networks.

IPX ping: 0xAB12.0xCD1234 is unreachable

Note: If you issue an IPX ping to an entity on a Token Ring network, you must

enter the host portion of the IPX address in byte-swapped form (noncanonical

form).

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 351 352

Sin comentarios

Avaya Using Technician Interface Software Manual de usuario Pagina 75