Avaya Using Technician Interface Software Manual de usuario descargar pdf (Pagina 100)

Using Technician Interface Software

4-12

Transferring a File

Depending on conditions existing within your network, you can transfer ﬁles

between Bay Networks routers and remote workstations using either of two

methods:

• In-band (using Technician Interface

tftp commands and a route through your

high-speed, IP network)

• Out-of-band (using Technician Interface

xmodem commands and a route

through a lower-speed, dial network)

You can transfer a ﬁle in-band whenever

• You can dial in to the Technician Interface port of a router you choose as

source or destination for a ﬁle transfer operation

• An operational IP routing path exists through your network, between the ﬁle

source (a router or a remote workstation) and the ﬁle destination (also a router

or a remote workstation)

Out-of-band ﬁle transfers are typically a less efﬁcient but sometimes useful

method, for example, for router diagnosis and management.

You use this method most beneﬁcially when

• You can dial in to the Technician Interface port of a router you choose as the

source or destination for a ﬁle transfer operation

• All IP routing paths between the ﬁle source and the ﬁle destination are down

(nonoperational)

You can use either a UNIX or a 386/486 DOS remote workstation to transfer ﬁles

in-band or out-of-band using Technician Interface

xmodem commands, as

operating conditions within your network allow.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 351 352

Sin comentarios

Avaya Using Technician Interface Software Manual de usuario Pagina 100