Avaya Using Technician Interface Software Manual de usuario descargar pdf (Pagina 258)

Using Technician Interface Software

A-8

Supported Traps

The following generic traps are supported by the software:

ipAddrEntry In certain circumstances, the index to this table, ipAdEntAddr,

may not be sufﬁcient to uniquely identify a particular instance.

In these situations, the attribute ipAdEntIfIndex is appended to

the instance identiﬁer for subsequent entries with the same

index.

ipRouteEntry The instance identiﬁer for the MIB-II routing table,

ipRouteDest, is insufﬁcient to uniquely identify all possible

routes to a given destination. The MIB-II routing table,

therefore, contains only a representative sample of the total

routing table. For a more accurate description of the system’s IP

routes, see wfIpForward Entry (1.3.6.1.4.1.18.3.5.3.2.1.16.1),

which is indexed by destination address, destination subnet

mask, route source, policy, and next-hop address.

coldStart Issued when the network management entity

initializes. The cold-start trap is delayed up to 30

seconds to give the network interfaces time to

initialize, thus improving the chances that the trap

will be received by all the registered managers of this

device.

warmStart Issued when the management protocol is re-enabled

after being disabled.

linkUp Issued when an interface has been initialized and is

providing service to upper layers. Note that during

system initialization, the transmission of link traps

may be masked because the network layer may not be

fully initialized and ready to send traps.

linkDown Issued when an interface is no longer providing

service.

authenticationFailure Issued when an SNMP access occurs. An invalid

access occurs if a bad community or illegal manager

address is used. Authentication traps will be masked if

they are not enabled.

1 2 ... 253 254 255 256 257 258 259 260 261 262 263 ... 351 352

Sin comentarios

Avaya Using Technician Interface Software Manual de usuario Pagina 258