Avaya Using Technician Interface Software Manual de usuario descargar pdf (Pagina 319)

Using Syslog Messaging to Monitor Router Events

C-25

b. Re-enable an entity ﬁlter by entering the following command line:

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrDisable.

<wfSyslogEntFltrHostIndex>.<wfSyslogEntFltrNum>.

1;commit

Re-enabling a ﬁlter

• Transitions the operational state of that ﬁlter

(wfSyslogHostOperState) to ACTIVE

• Allows Syslog to resume forwarding event messages through that

ﬁlter

Deleting Remote Hosts or Entity Filters from the Syslog Conﬁguration

You can delete a remote host from the Syslog host table, or delete a ﬁlter from the

Syslog ﬁlter table, as follows:

1. If you want to delete a remote host entry from the Syslog host table, enter

the following command line:

$: set wfSyslogHostEntry.wfSyslogHostDelete.

2;commit

2. If you want to delete a ﬁlter from the Syslog Entity Filter table, enter the

following command line:

$: set

wfSyslogEntFltrEntry.wfSyslogEntFltrDelete.

<wfSyslogEntFltrHostIndex>.

2;commit

Save the changes to your conﬁguration. (Refer to Task 8, earlier in this

appendix.)

Deleting Syslog from the Router

If you want to delete Syslog from the router, change the setting for

wfSyslogDelete, a global parameter/attribute, as follows:

$:set wfSyslog.wfSyslogDelete.0 2;commit

1 2 ... 314 315 316 317 318 319 320 321 322 323 324 ... 351 352

Sin comentarios

Avaya Using Technician Interface Software Manual de usuario Pagina 319