Avaya Using Technician Interface Software Manual de usuario descargar pdf (Pagina 44)

Using Technician Interface Software

2-2

Overview

You access the Technician Interface software through a console or modem

attached to a router serial port. The number of Technician Interface sessions you

can establish for a router depends on the number of serial ports available on that

router.

• The SRM-L board has one serial port (labeled “Console”), allowing you to

establish 1 session.

• The SYS I/O board has 3 serial ports (labeled “Console,”

“Modem 1” and “Modem 2”), allowing you to establish up to 3 sessions.

• The AFN motherboard has two serial ports (labeled “Console” and

“Modem”), allowing you to establish 1 or 2 sessions.

• The AN motherboard has 1 serial port (labeled “Console”), allowing you to

establish 1 session.

• The ASN motherboard has one serial port per router, with up to 4 routers

stacked, allowing you to establish up to 4 sessions with the interconnected

stack.

Refer to Conﬁguring Routers if you prefer to user Site Manager to conﬁgure the

serial port parameters for the router console.

Conﬁguring Console Port Parameters

The following sections describe how to use the following Technician Interface

commands:

• list

• set

• commit

•save

Using the list Command

You can list and review all serial port attributes by entering the following

command line at the Technician Interface prompt:

list wfSerialPortEntry

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 351 352

Sin comentarios

Avaya Using Technician Interface Software Manual de usuario Pagina 44