Avaya Using Technician Interface Software Manual de usuario descargar pdf (Pagina 317)

Using Syslog Messaging to Monitor Router Events

C-23

Managing Syslog on a Router

Once you ﬁnish conﬁguring Syslog on a router, you may occasionally need to

• Disable or re-enable the entire Syslog entity on the router. (Refer in this

section to “Disabling or Re-enabling Syslog on the Router.”)

• Disable or re-enable a Syslog host or ﬁlter on the router. (Refer in this section

to “Disabling or Re-enabling Syslog Hosts or Filters.”)

• Delete remote hosts or entity ﬁlters from the current Syslog conﬁguration.

(Refer in this section to “Deleting Remote Hosts or Entity Filters from the

Syslog Conﬁguration.”)

• Delete Syslog from the router. (Refer in this section to “Deleting Syslog from

the Router.”)

Disabling or Re-enabling Syslog on the Router

You can, if necessary, disable the Syslog service anytime after enabling it on a

router. Enter the following command line to disable Syslog:

$: set wfSyslog.wfSyslogDisable.0 2;commit

Disabling Syslog on the router

• Transitions all Syslog hosts and their ﬁlters to an INACTIVE operational state

in the router conﬁguration

• Halts all message forwarding from Syslog to any Syslog hosts conﬁgured on

the router

You can also re-enable Syslog after disabling it on a router. Enter the following

command line to re-enable Syslog:

$: set wfSyslog.wfSyslogDisable.0 1;commit

Re-enabling Syslog on the router

• Transitions Syslog hosts and their ﬁlters to an ACTIVE operational state in

the router conﬁguration. (Only n Syslog host entries transition to the ACTIVE

state, where n = the value of wfSyslogMaxHosts.)

• Resumes all message forwarding from Syslog to Syslog hosts conﬁgured on

the router. (Syslog forwards messages to n hosts only, where n = the value of

wfSyslogMaxHosts.)

1 2 ... 312 313 314 315 316 317 318 319 320 321 322 ... 351 352

Sin comentarios

Avaya Using Technician Interface Software Manual de usuario Pagina 317