Avaya Configuring Dial Services Manual de usuario Pagina 442

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 482
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 441
Configuring Dial Services
B-20
117353-B Rev. 00
Dial Backup over an ISDN Network
This ISDN example assumes the following:
All BRI connections use a National ISDN 1 (NI1) switch.
There is no incoming call filtering.
Sending complete IEs are not used for call setup.
The adaption rate is 64 Kb/s.
CHAP is the PPP authentication protocol.
IP is the only LAN protocol configured.
The Ethernet segments shown in the network illustration are not configured.
Only one phone number and SPID are used. (BRI lines usually have two
phone numbers and SPIDs.)
Figure B-4
shows dial backup service over an ISDN network. In this
configuration, the primary circuit is using PPP.
Figure B-4. Dial Backup over an ISDN Network
You can configure the routers for this network using Site Manager or the BCC.
For instructions, go to one of the following sections:
Configuring Dial Backup Using Site Manager
on page B-21
Configuring Dial Backup Using the BCC on page B-26
ISDN
ASN
AN
Router 1 Router 2
S131
.1
S12
.2
140.1.1.0
ISDN 1
ISDN 1
Local phone no: 4364444
Switch type: NI1
CHAP local name: ASN
CHAP secret: ISDN
Local phone no: 4363333
Switch type: NI1
CHAP local name: AN
CHAP secret: ISDN
DS0025A
Vista de pagina 441
1 2 ... 437 438 439 440 441 442 443 444 445 446 447 ... 481 482

Comentarios a estos manuales

Sin comentarios