
Configuring Dial Services
9-34
117353-B Rev. 00
Modifying ISDN Configurations
This section describes how to modify ISDN configurations. It contains the
following sections:
Modifying the MCT1 and MCE1 Port Configurations
The defaults for the port parameters work for most configurations; however, you
can modify the physical interface of the MCT1 and MCE1 ports.
To modify the MCT1 and MCE1 configurations using the BCC or Site Manager,
see Configuring WAN Line Services.
Topic Page
Modifying the MCT1 and MCE1 Port Configurations
9-34
Modifying the BRI and PRI Modes of Operation 9-35
Configuring Selective PRI Service 9-35
Modifying the ISDN Pool Channel Count 9-36
Modifying the ISDN Pool Channel Priority 9-38
Modifying the ISDN Switch Type 9-39
Enabling Incoming Call Filtering 9-40
Modifying the Adaption Rate 9-41
Informing the Switch That Call Setup Is Complete 9-43
Configuring X.25 over a D Channel (BRI only) 9-44
Modifying BRI Signaling over the D Channel 9-48
Modifying the X.25 Circuit for Service over the D Channel 9-52
Modifying the X.25 Circuit for Service over the D Channel 9-52
Modifying BRI Leased-Line Configurations (Germany and Japan only) 9-53
Deleting BRI and PRI from the Router 9-56
Deleting BRI 9-56
Deleting PRI 9-57
Comentarios a estos manuales