
Configuration Examples
117353-B Rev. 00
B-13
Configuring Dial Backup Using Site Manager
The following sections show how to configure dial backup with PPP on the
primary line using Site Manager.
Configuration of Router 1
To create the dial backup configuration in Figure B-3
on page B-12, configure
Router 1 as follows:
1.
Configure a leased, synchronous interface named S11.
2.
Select PPP or Standard as the WAN protocol.
3.
Select IP/RIP as the LAN protocol and configure the interface as follows:
• IP Address: 129.122.3.1
4.
From the Configuration Manager window, click on a COM connector.
5.
Follow the path to the configuration windows and set the parameters
according to Tables B-16
through B-20.
Configuration of Router 2
To create the dial backup configuration in Figure B-3
on page B-12, configure
Router 2 as follows:
1.
Configure a leased, synchronous interface named S331.
2.
Select PPP or Standard as the WAN protocol.
3.
Select IP/RIP as the LAN protocol and configure the interface as follows:
• IP Address: 129.122.3.2
4.
From the Configuration Manager window, click on a COM connector.
5.
Follow the path to the configuration windows and set the parameters
according to Tables B-16
through B-20.
Note:
These tables list only the parameter defaults you must change.
Comentarios a estos manuales