Avaya Configuring IP Services Manual de usuario Pagina 563

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 585
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 562
117356-A Rev. A E-1
Appendix E
IP/OSPF Configuration
The IP/OSPF configuration in Figure E-1 shows an AS divided into different types
of OSPF areas using several types of OSPF routers and interfaces as well as
variable-length subnetting. This appendix describes parameter settings for Router
1 through Router 6. Routers W through Z and A through D are included on the
network map for completion.
In the configuration in F
igure E-1:
The OSPF Area Authentication parameter is set to none for all areas.
All Timer parameter values are left at their defaults (Hello, Dead, and Poll
Interval).
No virtual links are configured.
Route summarization is not used.
The frame relay cloud is set to the default management type. It is non-fully
meshed with all Group Mode PVCs.
There are three area border routers (Router 2, Router 3, and Router 4), two
internal backbone routers (Router 1 and Router 5) and one AS boundary
router (Router 6 has an Ethernet interface using RIP).
R2 is the designated router for the FDDI segment. Router 4 must be the
designated router for the frame relay cloud.
Vista de pagina 562
1 2 ... 558 559 560 561 562 563 564 565 566 567 568 ... 584 585

Comentarios a estos manuales

Sin comentarios