
Customizing IP Services
117356-A Rev. A 4-43
Disabling UDP Checksum Processing on the Interface
By default, UDP checksum processing is enabled on this interface. All outgoing
and incoming UDP datagrams are subject to checksum processing. You can use
the BCC or Site Manager to turn this feature on an off as required.
Using the BCC
Navigate to an IP interface-specific prompt and enter
udp-checksum
state
state is
on (default)
off
For example, the following command turns off UDP checksum processing on IP
interface 2.2.2.2.
ip/2.2.2.2# udp-checksum off
ip/2.2.2.2#
Comentarios a estos manuales