Avaya Configuring Frame Relay Services Manual de usuario descargar pdf (Pagina 123)

Customizing SVCs

308624-14.10 Rev 01

5-13

Initiation Mode

Initiation mode determines the action LAPF will take to initiate link setup by

sending or holding unnumbered parameter (SABME) frames to poll the router at

the other end of the connection.

To set the initiation mode, navigate to the lapf prompt (for example,

box;

serial/1/2; frame-relay/1/2; lapf/3/2

) and enter:

initiation-mode

<mode>

mode

can be:

active

(the default) -- LAPF will send SABME frames and initiate link setup.

passive

-- LAPF takes no action to initiate link setup.

For example, the following command line sets a passive initiation mode:

lapf/3/2#

initiation-mode passive

lapf/3/2#

Retransmission Timer

The retransmission timer is used during initiation of LAPF multiple frame

support, and for timeout of LAPF numbered information frames. In the event of a

timeout, the sending platform retransmits the frame, up to the maximum number

of times you specify for retransmission limit.

To set the retransmission timer, navigate to the lapf prompt (for example,

box;

serial/1/2; frame-relay/1/2; lapf/3/2

) and enter:

retransmission-timer

integer

is the length of time that the router waits to receive an acknowledgment.

The value can be from 1 to 1200 tenths of a second. The default is 15.

For example, the following command line sets a timer of 30 tenths of a second (3

seconds):

lapf/3/2#

retransmission-timer 30

lapf/3/2#

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 245 246

Sin comentarios

Avaya Configuring Frame Relay Services Manual de usuario Pagina 123