Avaya Configuring AppleTalk Services Manual de usuario Pagina 91

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 120
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 90
Editing AppleTalk Parameters
117366-A Rev. A 4-5
Parameter: Enable
Default: Enable
Options: Enable
| Disable
Function: Enables or disables AppleTalk on this interface.
Instructions: Set to Disable only if you want AppleTalk disabled on this interface (for
example, if you are editing the interface’s zone list).
MIB Object ID: 1.3.6.1.4.1.18.3.5.4.3.1#2
Parameter: Network Start
Default: 0
Options: 0 to 65279
Function: Specifies the lower boundary (minimum) of the range of network
numbers that are available for use by nodes on the network to which this
interface connects.
This parameter’s setting determines whether this interface functions as a
seed or nonseed router.
Instructions: To configure this interface as a nonseed router, accept the default, 0.
To configure this interface as a seed router, specify the Network Start
parameter as follows:
If this is the only seed router on the network, determine the network
range for this interface and enter the lower boundary network number
here.
If there are already seed routers on the network, enter the same
Network Start value that is configured on all other seed routers.
MIB Object ID: 1.3.6.1.4.1.18.3.5.4.3.1#13
Note: If you specify a Network Start other than the default 0, then
(1) the router becomes a seed router automatically, and (2) you must also
specify values for the Network End and Default Zone parameters.
Vista de pagina 90
1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 119 120

Comentarios a estos manuales

Sin comentarios