Avaya Configuring AppleTalk Services Manual de usuario Pagina 46
- Pagina / 120
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Configuring AppleTalk Services
2-8 117366-A Rev. A
Enabling AppleTalk Routing and Bridging on the Same
Interface
If you enable both AppleTalk routing and bridging on the same interface,
configure a bridge filter on the interface to drop all AppleTalk Phase 2 AARP and
DDP packets.
If you do not configure a filter, you may experience problems when you reboot the
router. (This is because the bridge enables ahead of the AppleTalk router, causing
packets to be bridged before AppleTalk routing starts.)
We suggest creating a filter that specifies a drop (with no log) action on all SNAP
packets with Ethertype ranges of 0x809B to 0x809B and 0x80F3 to 0x80F3. The
hierarchical menu for the field is as follows:
Data link – 802.2 SNAP – 802.2 SNAP Ethertype
See Configuring Traffic Filters and Protocol Prioritization for more information
about how to construct filters for the bridge.
Specifying AppleTalk Zone Information
This section describes information specific to configuring AppleTalk zone
information.
Adding or Removing AppleTalk Zones
When a router initially learns about a new network, it sends out query packets
requesting the network’s zone information. The router uses this information to
update its zone table. However, because routers query for this information only
the first time they learn about a network, any changes later made to the network’s
zone list do not propagate to other routers on the internet.
To add, remove, or change an AppleTalk zone from an AppleTalk interface’s zone
list or default zone, follow this procedure:
1. Disable all AppleTalk router interfaces (both Bay Networks and
otherwise) that connect to the network for which the zone name change is
being applied.
- Configuring AppleTalk 1
- Services 1
- Contents 5
- 117366-A Rev. A 10
- About This Guide 13
- Conventions 14
- Acronyms 14
- Bay Networks Customer Service 16
- How to Get Help 16
- Chapter 1 17
- AppleTalk Overview 17
- AppleTalk Addresses 18
- AppleTalk Zones 20
- Figure 1-4. DDP Packet 25
- 1-10 117366-A Rev. A 26
- Figure 1-5. RTMP Data Packet 26
- 1-12 117366-A Rev. A 28
- Name Binding Protocol (NBP) 29
- AppleTalk Echo Protocol (AEP) 30
- 1-18 117366-A Rev. A 34
- 1-20 117366-A Rev. A 36
- For More Information 37
- Chapter 2 39
- 2-2 117366-A Rev. A 40
- 117366-A Rev. A 2-3 41
- 2-4 117366-A Rev. A 42
- 117366-A Rev. A 2-5 43
- Specifying Interface Costs 44
- 117366-A Rev. A 2-7 45
- APT0013A 45
- Interface 46
- 117366-A Rev. A 2-9 47
- Using AppleTalk Zone Filters 48
- 117366-A Rev. A 2-11 49
- 2-12 117366-A Rev. A 50
- 117366-A Rev. A 2-13 51
- 2-14 117366-A Rev. A 52
- 117366-A Rev. A 2-15 53
- 2-16 117366-A Rev. A 54
- 117366-A Rev. A 2-17 55
- 2-18 117366-A Rev. A 56
- 117366-A Rev. A 2-19 57
- 2-20 117366-A Rev. A 58
- 117366-A Rev. A 2-21 59
- 2-22 117366-A Rev. A 60
- 117366-A Rev. A 2-23 61
- 2-24 117366-A Rev. A 62
- 117366-A Rev. A 2-25 63
- 3-3 Engineering (Rule 1) 63
- 2-26 117366-A Rev. A 64
- Token Ring Networks 65
- 2-28 117366-A Rev. A 66
- Frame Relay Topology 67
- 2-30 117366-A Rev. A 68
- Topology 68
- AURP Information 69
- Setting the Update Rate 70
- 117366-A Rev. A 2-33 71
- 2-34 117366-A Rev. A 72
- Figure 2-22. Network Loop 72
- Setting Zone Filters 73
- Setting the Interface Cost 73
- 2-36 117366-A Rev. A 74
- Chapter 3 75
- Enabling AppleTalk Services 75
- 3-2 117366-A Rev. A 76
- 3-4 117366-A Rev. A 78
- Configuring the Zone List 79
- Click on Add 80
- 117366-A Rev. A 3-7 81
- Configuring AURP 82
- 117366-A Rev. A 3-9 83
- 117366-A Rev. A 3-11 85
- Chapter 4 87
- 4-2 117366-A Rev. A 88
- 4-6 117366-A Rev. A 92
- 4-8 117366-A Rev. A 94
- 4-10 117366-A Rev. A 96
- 117366-A Rev. A 4-13 99
- 117366-A Rev. A 4-15 101
- Editing the Zone Filter Type 103
- 4-18 117366-A Rev. A 104
- 117366-A Rev. A 4-19 105
- Globally Deleting AppleTalk 107
- 108
- 4-24 117366-A Rev. A 110
- Editing AppleTalk Parameters 111
- 4-28 117366-A Rev. A 114
- Appendix A 115
- AppleTalk Default Settings 115
- (continued) 116
- 117366-A Rev. A Index-1 117
- 117366-A Rev. A Index-3 119
Relacionado con productos y manuales para Redes Avaya Configuring AppleTalk Services
Redes Avaya 1220 Manual de usuario
(180 paginas)
(180 paginas)
Redes Avaya Configuring OSI Services Manual de usuario
(138 paginas)
(138 paginas)
Redes Avaya BCM Imaging Tool Guía de usuario
(42 paginas)
(42 paginas)
Redes Avaya BCM50 Guía de usuario
(40 paginas)
(40 paginas)
Redes Avaya R6.0 Nota de aplicación
(30 paginas)
(30 paginas)
Redes Avaya AP-8 Nota de aplicación
(22 paginas)
(22 paginas)
Redes Avaya Configuring ATM Services Manual de usuario
(268 paginas)
(268 paginas)
Redes Avaya Configuring APPN Services Manual de usuario
(150 paginas)
(150 paginas)
Redes Avaya R1.3 Guía de configuración
(13 paginas)
(13 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.022 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales