
Enabling AppleTalk Services
117366-A Rev. A 3-9
3.
Enter the appropriate IP address (using dotted-decimal notation) in the
Local IP Address field.
4. Click on OK to exit the window and save your changes when you are
finished.
Parameter: Enable
Default: Enable
Options: Enable | Disable
Function: Enables or disables AURP on the router.
Instructions: Set to Enable to globally enable AURP.
MIB Object ID: 1.3.6.1.4.1.18.3.5.4.8.2
Parameter: Local IP Address
Default: None
Options: Any valid 32-bit IP address in dotted decimal notation
Function: Identifies an IP interface on the router. This is the IP interface used for
AURP.
Instructions: Enter the IP address of the interface on this router that AURP should use.
MIB Object ID: 1.3.6.1.4.1.18.3.5.4.8.5
To configure the AURP connection, enter the IP address for the remote peer. To do
this, begin at the Configuration Manager window:
1. Select Protocols > AppleTalk > AURP > Interfaces.
The AT AURP Interface Configuration window appears (F
igure 3-5).
Comentarios a estos manuales