Avaya Configuring AppleTalk Services Manual de usuario Pagina 41

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 120
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 40
AppleTalk Implementation Notes
117366-A Rev. A 2-3
Make sure you configure the AppleTalk parameters as follows:
Set the Network Start parameter to the desired value.
Set the Network End parameter to 0, which indicates that the network is
nonextended.
Set the Default Zone parameter for the interface. The network can have only
one zone, the Default Zone.
Set the Network ID and the Node ID for the interface.
F
igure 2-1 shows a sample AppleTalk Interface Configuration window for a
nonextended configuration. Note that in the figure, the Network End equals 0.
Figure 2-1. AppleTalk Nonextended Configuration over PPP
Note: If two routers are running Bay Networks Version 7.70 router software or
higher, and you want to configure an interface for AppleTalk over PPP on each
router, both interfaces must be configured the same way for an extended or
nonextended network.
Vista de pagina 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 119 120

Comentarios a estos manuales

Sin comentarios