Avaya Configuring AppleTalk Services Manual de usuario Pagina 69
- Pagina / 120
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
AppleTalk Implementation Notes
117366-A Rev. A 2-31
Adding a Bay Networks AppleTalk Router to a Transitional Network
You can add the Bay Networks AppleTalk router to a transitional network (one
that generates both AppleTalk Phase 1 and AppleTalk Phase 2 traffic). For
performance reasons, however, we do not recommend it.
If you choose to add the Bay Networks AppleTalk router to a transitional network,
you must consider the following configuration requirements:
• An AppleTalk Phase 1 to Phase 2 transitional router must reside on the
internet.
• All defined network ranges must consist of a single number; for example, 1-1
is a valid network range, while 1-5 is invalid.
• You can only specify a single zone name for each network.
AURP Information
Before configuring AURP on a router, you must configure AppleTalk on at least
one of the router’s circuits. Then you can use AURP to create a wide-area link
between two or more AppleTalk networks.
Unlike other AppleTalk protocols, AURP does not require you to configure any
circuits for AURP services. Use AURP to configure the router’s interface to
another router that is set up for AURP services (known as the peer IP address).
Deciding When to Use AURP
You may find AURP desirable when faced with one of the following scenarios:
• You want to link two or more AppleTalk networks across an existing IP
internet.
• You want to reduce the amount of RTMP traffic on an AppleTalk network.
• You have a large AppleTalk network that is approaching the 15-hop AppleTalk
limit.
If possible, use AURP without RTMP in a nonloop topology.
- Configuring AppleTalk 1
- Services 1
- Contents 5
- 117366-A Rev. A 10
- About This Guide 13
- Conventions 14
- Acronyms 14
- Bay Networks Customer Service 16
- How to Get Help 16
- Chapter 1 17
- AppleTalk Overview 17
- AppleTalk Addresses 18
- AppleTalk Zones 20
- Figure 1-4. DDP Packet 25
- 1-10 117366-A Rev. A 26
- Figure 1-5. RTMP Data Packet 26
- 1-12 117366-A Rev. A 28
- Name Binding Protocol (NBP) 29
- AppleTalk Echo Protocol (AEP) 30
- 1-18 117366-A Rev. A 34
- 1-20 117366-A Rev. A 36
- For More Information 37
- Chapter 2 39
- 2-2 117366-A Rev. A 40
- 117366-A Rev. A 2-3 41
- 2-4 117366-A Rev. A 42
- 117366-A Rev. A 2-5 43
- Specifying Interface Costs 44
- 117366-A Rev. A 2-7 45
- APT0013A 45
- Interface 46
- 117366-A Rev. A 2-9 47
- Using AppleTalk Zone Filters 48
- 117366-A Rev. A 2-11 49
- 2-12 117366-A Rev. A 50
- 117366-A Rev. A 2-13 51
- 2-14 117366-A Rev. A 52
- 117366-A Rev. A 2-15 53
- 2-16 117366-A Rev. A 54
- 117366-A Rev. A 2-17 55
- 2-18 117366-A Rev. A 56
- 117366-A Rev. A 2-19 57
- 2-20 117366-A Rev. A 58
- 117366-A Rev. A 2-21 59
- 2-22 117366-A Rev. A 60
- 117366-A Rev. A 2-23 61
- 2-24 117366-A Rev. A 62
- 117366-A Rev. A 2-25 63
- 3-3 Engineering (Rule 1) 63
- 2-26 117366-A Rev. A 64
- Token Ring Networks 65
- 2-28 117366-A Rev. A 66
- Frame Relay Topology 67
- 2-30 117366-A Rev. A 68
- Topology 68
- AURP Information 69
- Setting the Update Rate 70
- 117366-A Rev. A 2-33 71
- 2-34 117366-A Rev. A 72
- Figure 2-22. Network Loop 72
- Setting Zone Filters 73
- Setting the Interface Cost 73
- 2-36 117366-A Rev. A 74
- Chapter 3 75
- Enabling AppleTalk Services 75
- 3-2 117366-A Rev. A 76
- 3-4 117366-A Rev. A 78
- Configuring the Zone List 79
- Click on Add 80
- 117366-A Rev. A 3-7 81
- Configuring AURP 82
- 117366-A Rev. A 3-9 83
- 117366-A Rev. A 3-11 85
- Chapter 4 87
- 4-2 117366-A Rev. A 88
- 4-6 117366-A Rev. A 92
- 4-8 117366-A Rev. A 94
- 4-10 117366-A Rev. A 96
- 117366-A Rev. A 4-13 99
- 117366-A Rev. A 4-15 101
- Editing the Zone Filter Type 103
- 4-18 117366-A Rev. A 104
- 117366-A Rev. A 4-19 105
- Globally Deleting AppleTalk 107
- 108
- 4-24 117366-A Rev. A 110
- Editing AppleTalk Parameters 111
- 4-28 117366-A Rev. A 114
- Appendix A 115
- AppleTalk Default Settings 115
- (continued) 116
- 117366-A Rev. A Index-1 117
- 117366-A Rev. A Index-3 119
Relacionado con productos y manuales para Redes Avaya Configuring AppleTalk Services
Redes Avaya 1220 Manual de usuario
(180 paginas)
(180 paginas)
Redes Avaya Configuring OSI Services Manual de usuario
(138 paginas)
(138 paginas)
Redes Avaya BCM Imaging Tool Guía de usuario
(42 paginas)
(42 paginas)
Redes Avaya BCM50 Guía de usuario
(40 paginas)
(40 paginas)
Redes Avaya R6.0 Nota de aplicación
(30 paginas)
(30 paginas)
Redes Avaya AP-8 Nota de aplicación
(22 paginas)
(22 paginas)
Redes Avaya Configuring ATM Services Manual de usuario
(268 paginas)
(268 paginas)
Redes Avaya Configuring APPN Services Manual de usuario
(150 paginas)
(150 paginas)
Redes Avaya R1.3 Guía de configuración
(13 paginas)
(13 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.041 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales