Avaya Configuring AppleTalk Services Manual de usuario Pagina 30
- Pagina / 120
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Configuring AppleTalk Services
1-14 117366-A Rev. A
An NBP named entity consists of the name, type, and zone name, where
• Name is the name assigned to the device that identifies it on the network.
• Type specifies the device type; for example, the type specified for a laser
printer is identified by the type LaserWriter.
• Zone name specifies the AppleTalk zone in which the device resides.
AppleTalk Echo Protocol (AEP)
The Bay Networks AppleTalk router supports the AppleTalk Echo Protocol
(AEP), which allows the router to respond to echo packets it receives from other
nodes on the network.
AppleTalk Update-based Routing Protocol (AURP)
The Bay Networks AppleTalk router supports the AppleTalk Update-based
Routing Protocol (AURP), which provides an optional set of features that you can
use with an AppleTalk Phase 2 network. AURP provides more efficient use of
network bandwidth, increased network security, and enables AppleTalk networks
to exchange data through a tunnel.
Bay Networks supports three major AURP features:
• AURP tunneling to allow AppleTalk communications over existing wide-area
Internet Protocol (IP) backbones
• Update-based routing table maintenance to reduce bandwidth use over a
tunnel
• Hop count reduction to extend the current AppleTalk 15-hop limit
The following sections provide a brief overview of the AURP features that Bay
Networks router software supports.
AURP Tunneling
AURP tunneling lets you connect two or more previously unconnected AppleTalk
internets over an IP internet (Figure 1-9). The sending router encapsulates each
AppleTalk data packet in IP and delivers it to the router on the other side of the
tunnel. The router receiving the encapsulated packet removes the IP header and
forwards the packet to the appropriate destination using standard AppleTalk
delivery mechanisms.
- Configuring AppleTalk 1
- Services 1
- Contents 5
- 117366-A Rev. A 10
- About This Guide 13
- Conventions 14
- Acronyms 14
- Bay Networks Customer Service 16
- How to Get Help 16
- Chapter 1 17
- AppleTalk Overview 17
- AppleTalk Addresses 18
- AppleTalk Zones 20
- Figure 1-4. DDP Packet 25
- 1-10 117366-A Rev. A 26
- Figure 1-5. RTMP Data Packet 26
- 1-12 117366-A Rev. A 28
- Name Binding Protocol (NBP) 29
- AppleTalk Echo Protocol (AEP) 30
- 1-18 117366-A Rev. A 34
- 1-20 117366-A Rev. A 36
- For More Information 37
- Chapter 2 39
- 2-2 117366-A Rev. A 40
- 117366-A Rev. A 2-3 41
- 2-4 117366-A Rev. A 42
- 117366-A Rev. A 2-5 43
- Specifying Interface Costs 44
- 117366-A Rev. A 2-7 45
- APT0013A 45
- Interface 46
- 117366-A Rev. A 2-9 47
- Using AppleTalk Zone Filters 48
- 117366-A Rev. A 2-11 49
- 2-12 117366-A Rev. A 50
- 117366-A Rev. A 2-13 51
- 2-14 117366-A Rev. A 52
- 117366-A Rev. A 2-15 53
- 2-16 117366-A Rev. A 54
- 117366-A Rev. A 2-17 55
- 2-18 117366-A Rev. A 56
- 117366-A Rev. A 2-19 57
- 2-20 117366-A Rev. A 58
- 117366-A Rev. A 2-21 59
- 2-22 117366-A Rev. A 60
- 117366-A Rev. A 2-23 61
- 2-24 117366-A Rev. A 62
- 117366-A Rev. A 2-25 63
- 3-3 Engineering (Rule 1) 63
- 2-26 117366-A Rev. A 64
- Token Ring Networks 65
- 2-28 117366-A Rev. A 66
- Frame Relay Topology 67
- 2-30 117366-A Rev. A 68
- Topology 68
- AURP Information 69
- Setting the Update Rate 70
- 117366-A Rev. A 2-33 71
- 2-34 117366-A Rev. A 72
- Figure 2-22. Network Loop 72
- Setting Zone Filters 73
- Setting the Interface Cost 73
- 2-36 117366-A Rev. A 74
- Chapter 3 75
- Enabling AppleTalk Services 75
- 3-2 117366-A Rev. A 76
- 3-4 117366-A Rev. A 78
- Configuring the Zone List 79
- Click on Add 80
- 117366-A Rev. A 3-7 81
- Configuring AURP 82
- 117366-A Rev. A 3-9 83
- 117366-A Rev. A 3-11 85
- Chapter 4 87
- 4-2 117366-A Rev. A 88
- 4-6 117366-A Rev. A 92
- 4-8 117366-A Rev. A 94
- 4-10 117366-A Rev. A 96
- 117366-A Rev. A 4-13 99
- 117366-A Rev. A 4-15 101
- Editing the Zone Filter Type 103
- 4-18 117366-A Rev. A 104
- 117366-A Rev. A 4-19 105
- Globally Deleting AppleTalk 107
- 108
- 4-24 117366-A Rev. A 110
- Editing AppleTalk Parameters 111
- 4-28 117366-A Rev. A 114
- Appendix A 115
- AppleTalk Default Settings 115
- (continued) 116
- 117366-A Rev. A Index-1 117
- 117366-A Rev. A Index-3 119
Relacionado con productos y manuales para Redes Avaya Configuring AppleTalk Services
Redes Avaya 1220 Manual de usuario
(180 paginas)
(180 paginas)
Redes Avaya Configuring OSI Services Manual de usuario
(138 paginas)
(138 paginas)
Redes Avaya BCM Imaging Tool Guía de usuario
(42 paginas)
(42 paginas)
Redes Avaya BCM50 Guía de usuario
(40 paginas)
(40 paginas)
Redes Avaya R6.0 Nota de aplicación
(30 paginas)
(30 paginas)
Redes Avaya AP-8 Nota de aplicación
(22 paginas)
(22 paginas)
Redes Avaya Configuring ATM Services Manual de usuario
(268 paginas)
(268 paginas)
Redes Avaya Configuring APPN Services Manual de usuario
(150 paginas)
(150 paginas)
Redes Avaya R1.3 Guía de configuración
(13 paginas)
(13 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.139 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales