Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual de usuario descargar pdf (Pagina 98)

98 Chapter 2 General CLI commands

212160-A

no rate-limit command

The no rate-limit command disables rate-limiting on the port. The syntax for

the

no rate-limit command is:

no rate-limit [port <portnum>]

The no rate-limit command is in the config-if command mode.

Table 46 describes the parameters and variables for the

no rate-limit

command.

Table 45 rate-limit command parameters and variables

Parameters and values Description

port <portnum> Specifies the port number to configure for rate-limiting.

Enter the port number you want to configure.

Note: If you omit this parameter, the system uses the port

number you specified in the

interface command.

multicast <pct>|broadcast <pct>|both <pct> Applies rate-limiting to the type of traffic. Enter an integer

between 1 and 10 to set the rate-limiting percentage:

• multicast—applies rate-limiting to multicast packets

• broadcast—applies rate-limiting to broadcast packets

• both—applies rate-limiting to both multicast and

broadcast packets

Table 46 no rate-limit command parameters and variables

Parameters and

variables

Description

port <portnum> Specifies the port number to disable for rate-limiting. Enter the port

number you want to disable.

Note: If you omit this parameter, the system uses the port number

you specified in the interface command.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 199 200

Sin comentarios

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual de usuario Pagina 98