Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual de usuario descargar pdf (Pagina 181)

Chapter 6 Policy-enabled networks and QoS 181

Reference for the Business Policy Switch 2000 Command Line Interface

Configuring QoS meters

Using the CLI, you set meters. You must set a meter when configuring QoS. You

can set a meter for either metered data or for nonmetered data.

If you want to meter, or police, the traffic, configure the committed rate, burst

rate, burst duration, in-profile action, and out-of-profile action.

For nonmetered data, configure only in-profile action.

update-1p Specifies whether 802.1p priority value should be updated or left

unchanged; unchanged equals ignore:

• ieee1p—enter the value you want; range is 0 to 7

• default—allows the value to be derived based on assignment of

other action parameters

• use-egress-map—uses the egress map to assign value

Default is default.

set-drop-prec

{loss-sensitive|not-

loss-sensitive|

default|use-egress

-map}

Enter the loss-sensitivity value you want:

• loss-sensitive

• not-loss-sensitive

• default

• use-egress-map

Default is use default.

Note: Certain options may be restricted based on the meter/policy

associated with the specific action.

You cannot delete an action that is referenced in an installed policy or

meter.

Table 105 qos action command parameters and variables (continued)

Parameters and

variables

Description

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 199 200

Sin comentarios

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual de usuario Pagina 181