Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual de usuario Pagina 68

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 200
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 67
68 Chapter 2 General CLI commands
212160-A
default telnet-access command
The default telnet-access command sets the Telnet settings to the default
values. The syntax for the
default telnet-access command is:
default telnet-access
The default telnet-access command is in the config command mode.
The
default telnet-access command has no parameters or values.
Setting server for Web-based management
You can enable or disable the Web server to use for the Web-based management
system. Refer to Using Web-based Management for the Business Policy Switch
2000 Software Version 1.2 for information on the Web-based management system.
This section discusses the following commands:
web-server, next
no web-server on page 69
Table 18 no telnet-access command parameters and variables
Parameters and
variables
Description
source-ip [<1-10>] Disables the Telnet access.
When you do not use the optional parameter, the source-ip list is
cleared, meaning the 1st index is set to 0.0.0.0./0.0.0.0. and the
2nd to 10th indexes are set to 255.255.255.255/255.255.255.255.
When you do specify a source-ip value, the specified pair is set to
255.255.255.255/255.255.255.255.
Note: These are the same source IP addresses as in the IP
Manager list. For more information on the IP Manager list, refer to
Chapter 3.
Vista de pagina 67
1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 199 200

Comentarios a estos manuales

Sin comentarios