Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual de usuario descargar pdf (Pagina 106)

106 Chapter 3 Security

212160-A

Using MAC address security

You configure the BaySecure* application using MAC addresses with the

following commands:

• “show mac-security command,” next

• “mac-security command” on page 107

• “mac-security mac-address-table address command” on page 108

• “mac-security security-list command” on page 109

• “no mac-security command” on page 110

• “no mac-security mac-address-table command” on page 110

• “no mac-security security-list command” on page 111

• “mac-security command for a specific port” on page 111

show mac-security command

The show mac-security command displays configuration information for the

BaySecure application. The syntax for the

show mac-security command is:

show mac-security {config|mac-address-table [address

<macaddr>]|port|security-lists}

The show mac-security command is in the privExec command mode.

Table 52 describes the parameters and variables for the

show mac-security

command.

Table 51 no ipmgr command for source IP addresses parameters and variables

Parameters and variables Description

source-ip [<1-10>] When you specify an option, it sets the IP address and

mask for the specified entry to 255.255.255.255 and

255.255.255.255.

When you omit the optional parameter, it resets the list to

factory defaults.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 199 200

Sin comentarios

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manual de usuario Pagina 106